Hot Tub / Spa
Everything you need for a relaxing soak
Quick Start Guide
The spa should be hot and ready for you when you arrive. To use it:
- 1
Remove the cover — Lift and set aside
- 2
Press "Jets" to turn on the jets
- • Press once = Low speed
- • Press twice = High speed
- • Press three times = Off
- 3
Enjoy your soak!
- 4
When finished — Replace the cover securely
Control Panel Buttons
| Button | What It Does |
|---|---|
| Jets | Turns on/off the main jets (press multiple times to cycle) |
| Blower | Turns on/off gentle air bubbles |
| Light | Turns spa light on/off |
| Warm ▲ | Raises temperature |
| Cool ▼ | Lowers temperature |
| Mode | Do not adjust — leave in current mode |
| Aux | Not connected to anything — you can ignore this one! |
Temperature is preset to 100°F — Feel free to adjust between 98-102°F for your comfort.
Spa Rules for Your Safety
✅ Please Do
- •Shower before entering (removes lotions, oils, deodorant)
- •Stay hydrated — Drink water before and after soaking
- •Limit soaks to 15-20 minutes at a time
- •Replace cover securely after each use
- •Let us know if anything seems wrong
❌ Please Don't
- •No glass in or around the spa (use plastic cups only)
- •No food in the spa
- •No oils, bath bombs, or bubbles — These damage the equipment
- •No children under 5 in the hot tub
- •No unsupervised children at any time
- •Don't adjust the Mode button (leave in Standard mode)
- •Don't drain or refill the spa
⚠️ Health & Safety Warnings
Do NOT use the spa if you:
- • Have been drinking alcohol
- • Are pregnant (consult your doctor first)
- • Have heart disease or blood pressure issues
- • Have open wounds or skin infections
- • Are feeling lightheaded or unwell
Water temperature should never exceed 104°F
Exit immediately if you feel:
- • Dizzy or lightheaded
- • Nauseous
- • Overheated
Temperature Adjustment
If the water is too hot or too cold:
- 1
Press Warm ▲ or Cool ▼ once to see the current set temperature
- 2
Press again to adjust (1 degree per press)
- 3
Wait — the spa heats approximately 3-6 degrees per hour
Recommended range: 98-102°F
After Your Soak
- 1
Turn off jets (press Jets button until they stop)
- 2
Exit the spa carefully (surfaces may be slippery!)
- 3
Replace the cover — This is important to:
- • Keep the water warm
- • Keep debris out
- • Save energy
Troubleshooting
| Problem | Solution |
|---|---|
| Jets won't turn on | Press the Jets button; make sure cover is fully removed |
| Water feels cold | Check display temperature; press Warm ▲ to increase; wait 1-2 hours |
| Display shows error code | Note the code and contact us |
| Water looks cloudy | Please contact us — do not use until resolved |
| Cover is difficult to remove | Lift from the right side, fold over to the left, then slide the whole cover to rest in the gap between the hot tub and the wall on the left |
Questions or Problems?
Please don't hesitate to reach out if anything isn't working properly!
Contact Us